WHERE ARE YOU?

DraftPros has a variety of service and maintenance programs and procedures. We custom design and price programs to meet your needs and budget. Maintenance plans vary due to travel distance and availability. To get a quote on service plans contact us. 

 

PREVENTATIVE MAINTENANCE AND SERVICE PLANS

Maintaining your long-draw or remote draft beer system is essential to delivering a consistent product to your customers. The best and most cost-effective way to ensure this is to have a regular, preventative service and maintenance program. Small, unseen issues that go untreated lead to bigger, much more costly failures in the future. With this in mind, DraftPro Systems service plans include the following:

• Glycol Chiller/Power Pack
  Clean condenser. Check air flow. Clean circulator air intake. Inspect pump assembly and check thermostat is working properly. Check glycol and refract, regenerate or replace if needed.

• Beer Lines and Components
  Check for leaks or cracks in beer lines. Ensure the FOB is working properly. Pressure check system with ulta-sonic leak detector.

• Air System
  Tighten all gas nuts on keg couplers. Inspect air system components and lines for damage. Pressure test system.

• Temperature Check
  Properly record walk-in cooler, glycol chiller and dispense temperatures.

• Consult
  Provide results and advise on any steps necessary to maintain proper operation.

 

 

RESCUE CLEAN AND BEER LINE RESET

If you haven’t been cleaning your lines properly, you may need a beer line “reset.” We use a highly concentrated cleaning solution that removes all stone, mold and other microbes that can grow in beer lines. This will ensure that the beer you serve tastes just as the brewer intended even if it has been a long time since your lines were cleaned.

If you’re unsure as to when the last time your beer lines were cleaned, you probably don’t have a pro-active, regular line cleaning program. If so, you would probably benefit from a line reset. Also, if your lines are yellow, cracking, molding or leaving sediments in beer…contact us.

​

​

​

JUMPER LINE REPLACEMENT

Jumper lines are the vinyl tubes that run from the keg to the trunkline. They are typically 6 ft. in length. These lines need to be replaced regularly as vinyl is porous and absorbs flavor. This can cause cross-flavor contamination. Also, normal wear and tear causes lines to become loose, broken or leaky. They should be inspected regularly, but a good rule of thumb is to replace the jumper lines when you replace your glycol annually.